高级检索

    全浸腐蚀条件下溶液pH对2A12-T4铝合金剥蚀的影响

    Effect of Solution pH on Exfoliation Corrosion of 2A12-T4 Aluminum Alloy under Full-Immersion Corrosion Condition

    • 摘要: 以EXCO标准溶液(pH为0.4)为基础,通过改变溶液pH为1和2,研究了全浸腐蚀条件下溶液pH对2A12-T4铝合金剥蚀行为的影响规律和机理。结果表明:随着溶液pH增加,试样在腐蚀初期的质量减少和腐蚀后期的质量增加幅度均明显降低,剥蚀程度明显减弱,且由全面剥蚀转变成局部剥蚀。试样在不同pH溶液中的截面剥蚀扩展特征基本相同。在pH=1的试验溶液中,试样经过192 h腐蚀后,其剥蚀扩展区的晶间腐蚀特征与海南万宁自然环境试验站7 a的非常相近,且均为局部剥蚀。在研究铝合金的大气局部剥蚀时,建议全浸溶液pH取1。

       

      Abstract: EXCO standard solution (pH 0.4) was used as the basic solution, and the influence of solution pH on the exfoliation corrosion behavior of 2A12-T4 aluminum alloy under full immersion corrosion conditions was studied by changing the solution pH to 1 and 2. The results showed that with the increase of solution pH, the mass reduction of samples at the initial stage of corrosion and the mass increment at the later stage of corrosion were significantly reduced, the degree of exfoliation corrosion was significantly weakened, and the overall exfoliation corrosion was transformed to localized exfoliation corrosion. The exfoliation corrosion propagation characteristics on the cross section of samples in the solutions with different pH were basically the same.In the test solution with pH=1, after 192 h of corrosion, the intergranular corrosion characteristics of the denuded extension zone of the sample were very similar to those in Hainan Wanning Natural Environment Test Station for 7 years, and they were all localized exfoliation corrosion.

       

    /

    返回文章
    返回